| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| soroban-fixed-point-math is a fixed-point math library for Soroban smart contacts. In versions 1.3.0 and 1.4.0, the `mulDiv(x, y, z)` function incorrectly handled cases where both the intermediate product $x * y$ and the divisor $z$ were negative. The logic assumed that if the intermediate product was negative, the final result must also be negative, neglecting the sign of $z$. This resulted in rounding being applied in the wrong direction for cases where both $x * y$ and $z$ were negative. The functions most at risk are `fixed_div_floor` and `fixed_div_ceil`, as they often use non-constant numbers as the divisor $z$ in `mulDiv`. This error is present in all signed `FixedPoint` and `SorobanFixedPoint` implementations, including `i64`, `i128`, and `I256`. Versions 1.3.1 and 1.4.1 contain a patch. No known workarounds for this issue are available. |
| An Incorrect Calculation vulnerability in the Layer 2 Control
Protocol
Daemon (l2cpd) of Juniper Networks Junos OS Evolved allows an unauthenticated network-adjacent attacker flapping the management interface to cause the learning of new MACs over label-switched interfaces (LSI) to stop while generating a flood of logs, resulting in high CPU usage.
When the issue is seen, the following log message will be generated:
op:1 flag:0x6 mac:xx:xx:xx:xx:xx:xx bd:2 ifl:13302 reason:0(REASON_NONE) i-op:6(INTRNL_OP_HW_FORCE_DELETE) status:10 lstatus:10 err:26(GETIFBD_VALIDATE_FAILED) err-reason 4(IFBD_VALIDATE_FAIL_EPOCH_MISMATCH) hw_wr:0x4 ctxsync:0 fwdsync:0 rtt-id:51 p_ifl:0 fwd_nh:0 svlbnh:0 event:- smask:0x100000000 dmask:0x0 mplsmask 0x1 act:0x5800 extf:0x0 pfe-id 0 hw-notif-ifl 13302 programmed-ifl 4294967295 pseudo-vtep underlay-ifl-idx 0 stack:GET_MAC, ALLOCATE_MAC, GET_IFL, GET_IFF, GET_IFBD, STOP,
This issue affects Junos OS Evolved:
* all versions before 21.4R3-S7-EVO,
* from 22.2 before 22.2R3-S4-EVO,
* from 22.3 before 22.3R3-S3-EVO,
* from 22.4 before 22.4R3-S2-EVO,
* from 23.2 before 23.2R2-S1-EVO,
* from 23.4 before 23.4R1-S2-EVO, 23.4R2-EVO. |
| iccDEV provides a set of libraries and tools that allow for the interaction, manipulation, and application of ICC color management profiles. Prior to 2.3.1.4, SrcPixel and DestPixel stack buffers overlap in CIccTagMultiProcessElement::Apply() int IccTagMPE.cpp. This vulnerability is fixed in 2.3.1.4. |
| The CombinedMult function in the CIRCL ecc/p384 package (secp384r1 curve) produces an incorrect value for specific inputs. The issue is fixed by using complete addition formulas.
ECDH and ECDSA signing relying on this curve are not affected.
The bug was fixed in v1.6.3 https://github.com/cloudflare/circl/releases/tag/v1.6.3 . |
| The Graph is an indexing protocol for querying networks like Ethereum, IPFS, Polygon, and other blockchains. Prior to version 3.0.0, a flaw in the token vesting contracts allows users to access tokens that should still be locked according to their vesting schedule. This issue has been patched in version 3.0.0. |
| A flaw was found in gix-date. The `gix_date::parse::TimeBuf::as_str` function can generate strings containing invalid non-UTF8 characters. This issue violates the internal safety invariants of the `TimeBuf` component, leading to undefined behavior when these malformed strings are subsequently processed. This could potentially result in application instability or other unforeseen consequences. |
| Incorrect calculation in microcode keying mechanism for some Intel(R) Xeon(R) D Processors with Intel(R) SGX may allow a privileged user to potentially enable information disclosure via local access. |
| The mstatus register in RSD commit 3d13a updates incorrectly, leading to processing errors. |
| When using a TarFile.errorlevel = 0 and extracting with a filter the documented behavior is that any filtered members would be skipped and not extracted. However the actual behavior of TarFile.errorlevel = 0 in affected versions is that the member would still be extracted and not skipped. |
| matrix-sdk-base is the base component to build a Matrix client library. In matrix-sdk-base before 0.14.1, calling the `RoomMember::normalized_power_level()` method can cause a panic if a room member has a power level of `Int::Min`. The issue is fixed in matrix-sdk-base 0.14.1. The affected method isn’t used internally, so avoiding calling `RoomMember::normalized_power_level()` prevents the panic. |
| era-compiler-solidity is the ZKsync compiler for Solidity. The problem occurred during instruction selection in the `DAGCombine` phase while visiting the XOR operation. The issue arises when attempting to fold the expression `!(x cc y)` into `(x !cc y)`. To perform this transformation, the second operand of XOR should be a constant representing the true value. However, it was incorrectly assumed that -1 represents the true value, when in fact, 1 is the correct representation, so this transformation for this case should be skipped. This vulnerability is fixed in 1.4.1. |
| In AMD Versal Adaptive SoC devices, the incorrect configuration of the SSS during runtime (post-boot) cryptographic operations could cause data to be incorrectly written to and read from invalid locations as well as returning incorrect cryptographic data. |
| Polkadot Frontier is an Ethereum and EVM compatibility layer for Polkadot and Substrate. The extrinsic note_min_gas_price_target is an inherent extrinsic, meaning only the block producer can call it. To ensure correctness, the ProvideInherent trait should be implemented for each inherent, which includes the check_inherent call. This allows other nodes to verify if the input (in this case, the target value) is correct. However, prior to commit a754b3d, the check_inherent function has not been implemented for note_min_gas_price_target. This lets the block producer set the target value without verification. The target is then used to set the MinGasPrice, which has an upper and lower bound defined in the on_initialize hook. The block producer can set the target to the upper bound. Which also increases the upper and lower bounds for the next block. Over time, this could result in continuously raising the gas price, making contract execution too expensive and ineffective for users. An attacker could use this flaw to manipulate the gas price, potentially leading to significantly inflated transaction fees. Such manipulation could render contract execution prohibitively expensive for users, effectively resulting in a denial-of-service condition for the network. This is fixed in version a754b3d. |
| A flaw was found in libssh versions built with OpenSSL versions older than 3.0, specifically in the ssh_kdf() function responsible for key derivation. Due to inconsistent interpretation of return values where OpenSSL uses 0 to indicate failure and libssh uses 0 for success—the function may mistakenly return a success status even when key derivation fails. This results in uninitialized cryptographic key buffers being used in subsequent communication, potentially compromising SSH sessions' confidentiality, integrity, and availability. |
| goxmlsig provides XML Digital Signatures implemented in Go. Prior to version 1.6.0, the `validateSignature` function in `validate.go` goes through the references in the `SignedInfo` block to find one that matches the signed element's ID. In Go versions before 1.22, or when `go.mod` uses an older version, there is a loop variable capture issue. The code takes the address of the loop variable `_ref` instead of its value. As a result, if more than one reference matches the ID or if the loop logic is incorrect, the `ref` pointer will always end up pointing to the last element in the `SignedInfo.References` slice after the loop. goxmlsig version 1.6.0 contains a patch. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/mm/ident_map: Use gbpages only where full GB page should be mapped.
When ident_pud_init() uses only GB pages to create identity maps, large
ranges of addresses not actually requested can be included in the resulting
table; a 4K request will map a full GB. This can include a lot of extra
address space past that requested, including areas marked reserved by the
BIOS. That allows processor speculation into reserved regions, that on UV
systems can cause system halts.
Only use GB pages when map creation requests include the full GB page of
space. Fall back to using smaller 2M pages when only portions of a GB page
are included in the request.
No attempt is made to coalesce mapping requests. If a request requires a
map entry at the 2M (pmd) level, subsequent mapping requests within the
same 1G region will also be at the pmd level, even if adjacent or
overlapping such requests could have been combined to map a full GB page.
Existing usage starts with larger regions and then adds smaller regions, so
this should not have any great consequence. |
| A flaw in DRBG number generation within the Network Security Services (NSS) library where the internal state V does not correctly carry bits over. The NSS library has been updated to fix this issue to address this issue and Firefox ESR 52.1 has been updated with NSS version 3.28.4. This vulnerability affects Thunderbird < 52.1, Firefox ESR < 45.9, Firefox ESR < 52.1, and Firefox < 53. |
| In the Linux kernel, the following vulnerability has been resolved:
blk_iocost: fix more out of bound shifts
Recently running UBSAN caught few out of bound shifts in the
ioc_forgive_debts() function:
UBSAN: shift-out-of-bounds in block/blk-iocost.c:2142:38
shift exponent 80 is too large for 64-bit type 'u64' (aka 'unsigned long
long')
...
UBSAN: shift-out-of-bounds in block/blk-iocost.c:2144:30
shift exponent 80 is too large for 64-bit type 'u64' (aka 'unsigned long
long')
...
Call Trace:
<IRQ>
dump_stack_lvl+0xca/0x130
__ubsan_handle_shift_out_of_bounds+0x22c/0x280
? __lock_acquire+0x6441/0x7c10
ioc_timer_fn+0x6cec/0x7750
? blk_iocost_init+0x720/0x720
? call_timer_fn+0x5d/0x470
call_timer_fn+0xfa/0x470
? blk_iocost_init+0x720/0x720
__run_timer_base+0x519/0x700
...
Actual impact of this issue was not identified but I propose to fix the
undefined behaviour.
The proposed fix to prevent those out of bound shifts consist of
precalculating exponent before using it the shift operations by taking
min value from the actual exponent and maximum possible number of bits. |
| In the Linux kernel, the following vulnerability has been resolved:
jfs: Fix shift-out-of-bounds in dbDiscardAG
When searching for the next smaller log2 block, BLKSTOL2() returned 0,
causing shift exponent -1 to be negative.
This patch fixes the issue by exiting the loop directly when negative
shift is found. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: don't allow mapping the MMIO HDP page with large pages
We don't get the right offset in that case. The GPU has
an unused 4K area of the register BAR space into which you can
remap registers. We remap the HDP flush registers into this
space to allow userspace (CPU or GPU) to flush the HDP when it
updates VRAM. However, on systems with >4K pages, we end up
exposing PAGE_SIZE of MMIO space. |
